Whites-electronics Spectrum XLT User Manual download pdf (Page 3)

Chapter 1 XLT

Assembly

readjust clevis/lower rod length with the sping clip

buttons so that the search coil can be held near the

floor without requiring stooping over.

7. Remove the protective paper from the two black

elbow cup foam pads. Carefully align pads on the

inside of the elbow cup, one on each side of the

center rod, and press firmly into place.

8. Adjust the elbow cup strap so that it is loose

enough for you to slide your arm in and out with-

out loosening each time you want to set the detec-

tor down. The elbow cup strap provides extra

leverage and control. However, some prefer not to

use it.

9. Install battery as described in the next section,

decal facing down, with plastic tab and steel contacts

facing toward inside of battery compartment.

10. It should be noted at this point that the detector

may not work as expected indoors due to the high

degree of metals used in modern construction. It is

best to tune and practice out-of-doors to ensure

stable, predictable results. Additionally, freshly-

buried targets will not produce the normal depth

and discrimination results of targets that have been

naturally lost and settled in the ground. Due to the

abnormality caused by digging a hole in the ground

matrix, and the sophistication of the ground rejec-

tion circuitry, it may take a number of years for

freshly-buried targets to respond at true depths and

discrimination accuracy. The best way to deter-

mine true detection depth is in real search condi-

tions.

Assembly Instructions

1. Remove all parts from shipping carton and

check the assembly page to make sure all parts are

present.

2. There are rubber washers between clevis/lower

rod and loop ears. Use only nonmetallic washers,

fiber bolt, and thumbnut to secure loop/search

coil to clevis/lower rod.

3. Unlock "S" rod camlock and insert clevis/

lower rod into curved "S" rod so that stainless

steel spring clip buttons line up and lock into one

of the adjustment holes in the curved "S" rod.

Turn camlock to secure. The second or third

adjustment holes are suitable for average size

adults. Individuals 6' or taller should use the fully

extended position. Individuals well over 6' tall

should purchase the optional Tall Man Rod.

4. Unravel loop cable and wind the cable around

the clevis and rod assembly, first revolution over

the top of the rod. Wind cable all the way to the

top of the curved "S" rod, about five revolutions.

Use the black cable retainers, one near the loop,

and one near the top of the curved "S" rod, to hold

the loop cable in place.

5. Unlock control box rod camlock and insert

curved "S" rod so that stainless steel spring clip

buttons line up and lock into the rod on top of the

control box. The "S" rod is designed to curve up

toward the display. However, those who prefer to

sweep the loop close to their feet may desire to

assemble the "S" rod to curve down toward the

ground. Turn camlock to secure. Plug loop con-

nector into control box, screw lock ring to secure.

6. Grip the instrument by the handle, with your arm in

the elbow cup with strap secure, and sweep the loop/

search coil over the floor. If the instrument fit feels

uncomfortable, adjust the elbow cup by removing

and repositioning the bolt/thumbnut and installing

in one of the optional positions. If necessary,

1 2 3 4 5 6 7 8 ... 55 56

Comments to this Manuals

No comments

Whites-electronics Spectrum XLT User Manual Page 3

Comments to this Manuals

Related products and manuals for Sports and recreation Whites-electronics Spectrum XLT